74161 DATASHEET PDF
datasheet, circuit, data sheet: TI – SYNCHRONOUS 4-BIT COUNTERS,alldatasheet, datasheet, Datasheet search site for Electronic. These synchronous, presettable counters feature an inter- nal carry look-ahead for application in high-speed counting designs. The DM74LSA and. 74LS datasheet, 74LS pdf, 74LS data sheet, datasheet, data sheet, pdf, Fairchild Semiconductor, Synchronous 4-Bit Binary Counters.
|Published (Last):||1 July 2009|
|PDF File Size:||13.42 Mb|
|ePub File Size:||11.42 Mb|
|Price:||Free* [*Free Regsitration Required]|
Message 5 of Message 8 of Message 2 of Please find attached the multisim model.
But, when the second counter’s RCO carries over to the third counters ENT it stays high for a long period of time the duration of the QA and sets off the third counter to “race at clock speed” similar to the first counter. I am asking because I found another post in this board that noted that the issue was resolved.
I am new to NI tools and new to the forums. Message 9 of I appreciate any insights.
They should form a simple 16 bit binary counter that keeps incrementing until all of the output bits for E4 are all zeros and then it loads all the counters with preset value. Message 10 of Most Active Software Boards: Thanks for sharing these files over here!
I am especially looking for information concerning the “old 70s design” you want to simulate. When connected to ENT as it appears to be done in the orignal schematics p21, Dataeheet to E4 the third counter starts to race at clock speed when RCO set ENT high as can be seen in the attached simulation screen shot.
Something wrong with the model? Message 4 of Thanks in advance for your feedback! This is not the case when connecting to ENP. The case is not solved – and I have now asked the moderator to remove the duplicate.
I am building a simulation of an old datasjeet design based on s and I have had a lot of trouble getting a datashheet of counters to operate according to my expectations.
Datasheet PDF –
For some reason i couldnt attach files with my message above, and i cannot post them separately either it appears Auto-suggest helps you quickly narrow down your search results by datasheef possible matches as you type. Message 7 of I tried to simulate the similar cascade in another simulation tool – and i get the reverse and expeced results; that when RCO is connect to ENT, the carry is forwarded and no “racing” occurs.
Unfortunately it did not solve my headache. Is the model that is being used in there shareable?
Message 6 of Can you provide me with the following information to help the troubleshooting? Do you have any information about the simulation tool you are comparing to? In the schematics the rco is connected to ENT. Message 3 of In my search for understanding more I discovered a recent document that had identified an error in the multisim model related to the counter executing on falling edge of clock, datzsheet be rising dwtasheet.
Question to the forum: Message 1 of